The TV must be used with a remote control, but the remote control is relatively small. Sometimes, it is very likely that you will not be able to find it when you put it away, which makes people feel very crazy. It doesn’t matter, we can buy a universal remote control, but many friends don’t know how to use it or how to automatically select channels. It doesn’t matter, we will take a look at the relevant knowledge immediately, and hope it will be helpful to everyone.

1. How to use the universal remote control for TV?

Install the battery first, turn on the power of the TV, long press the red button on the universal remote control, then activate the remote control, select the button of your TV brand, such as button 1 for Changhong TV, button 2 for LG TV, etc. Long press the corresponding number button, when the red indicator light of the remote control flashes, it proves that the remote control has been activated. If your TV has no corresponding button indication, press and hold the universal button, wait for the red light to flash before letting go. If there is a malfunction during the use of the universal remote control, long press the volume button of the remote control to try, and the red indicator light starts flashing and it returns to normal.

2. How to automatically select the channel of the universal remote control?

1) Turn on the power of the TV to be set, and point the universal remote control to the home appliance. (The left and right deviation should not exceed 30 degrees as far as possible).

2) Long press the setting button and the Ch+ button on the remote control, and then release the two buttons at the same time. (At this time, the signal light on the remote control will continue to flash, which means that the set model code is being searched at this time)

3)When the power of the TV is turned off, you need to press any button on the remote control quickly, and the action should be fast. Indicates a lock code.

4)Finally, press the power button on the remote control. If it can be operated, it proves that the setting has been completed. If it doesn’t work, you need to repeat the above steps again.